2.2.1 Windows® Installation
- Unzip the archive and run Chronos-Setup.exe.
- Respond to the prompts to install the software. During the installation a separate window opens for the Windows driver installation. Accept the driver installation.
NOTE
The eZ430-Chronos access point driver may not be certified by Microsoft. Therefore, Windows may generate a warning. Allow the driver installation to continue.
- When installation finishes, connect the eZ430-Chronos RF USB access point to the PC and follow the Windows driver installation (see Section 2.3).
- If prompted for the driver for the TI CC1111 Low-Power RF to USB CDC Serial Port (legacy software), or eZ430-ChronosAP (current software) allow Windows to 'Install the software automatically'. This can be done only if the eZ430-Chronos PC Software package has already been installed.
- Open the eZ430-Chronos Control Center program. A shortcut is available on the Desktop and the Start Menu under Programs > Texas Instruments > eZ430-Chronos > eZ430-Chronos Control Center.
For a detailed driver installation, see Section B.