SLAU292G November 2009 – July 2015
This mode requires the eZ430-Chronos Control Center PC software.
Press # until "SYnC" is shown (see Figure 3-1). This mode allows doing a variety of settings for the wrist module conveniently from the eZ430-Chronos Control Center PC software over the air (see Section 3.3.3).
Secondary function: Start or stop link for Sync Mode. Pushing DOWN starts/stops the pairing process or stop the link (the access point on the PC must be started first from the eZ430-Chronos Control Center (see Section 3.3.3). The RF icon on the LCD flashes when the radio is active. If the pairing fails, it disappears. After a successfully received message, the LCD shows "DONE". The top LCD line is off during the pairing and until the Sync Mode is disabled.
Set function: None