ZHCU948B September 2020 – May 2022 BQ76952
类别 | 子类别 | 名称 | 类型 | 最小值 | 最大值 | 默认值 | 单位 |
---|---|---|---|---|---|---|---|
Settings | Cell Balancing Config | Balancing Configuration | H1 | 0x00 | 0xFF | 0x00 | 十六进制 |
7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
RSVD_0 | RSVD_0 | RSVD_0 | CB_NO_CMD | CB_NOSLEEP | CB_SLEEP | CB_RLX | CB_CHG |
位 | 字段 | 默认值 | 说明 |
---|---|---|---|
4 | CB_NO_CMD | 0 | 如果不需要主机控制的平衡,该位允许阻止电芯平衡命令。 0 = 接受主机控制型平衡命令。 1 = 忽略主机控制型平衡命令。 |
3 | CB_NOSLEEP | 0 | 该位将器件配置为退出睡眠模式以执行电芯平衡。设置此位时,也应设置 CB_SLEEP。 0 = 电芯平衡处于运行状态时允许 SLEEP 模式。 1 = 电芯平衡处于运行状态时阻止 SLEEP 模式。 |
2 | CB_SLEEP | 0 | 该位配置是否允许器件在 SLEEP 模式下执行电芯平衡。 0 = 在 SLEEP 模式下不执行电芯平衡。 1 = 在 SLEEP 模式下可以执行电芯平衡。 |
1 | CB_RLX | 0 | 当电流低于 Settings:Current Thresholds:Chg Current Threshold 并高于 Settings:Current Thresholds:Dsg Current Threshold 时,该位启用电芯平衡。请注意,这仅适用于自动电芯平衡。主机控制型平衡不受该位影响。 0 = 在放松条件下不允许电芯平衡。 1 = 在放松条件下不允许电芯平衡。 |
0 | CB_CHG | 0 | 当电流高于 Settings:Current Thresholds:Chg Current Threshold 时,此位会启用电芯平衡。请注意,这仅适用于自动电池平衡。主机控制型平衡不受该位影响。 0 = 充电时不允许电芯平衡。 1 = 充电时允许电芯平衡。 |