4 Revision History
Changes from Revision A (May 2021) to Revision B (March 2023)
- 更新了首页上的典型功耗要点以匹配电气特性表Go
- Added note for supply noise frequency
rangeGo
- IDD_TOTAL typical value changed to 160 mAGo
- Changed I2C terminology to "Controller" and
"Target"Go
- Removed extra arrow from DPHY Receiver to Clock Gen blocks in
Functional Block Diagram Go
- Added description for non-continuous clock lane
modeGo
- Added description for deserializer SENSOR_STS
registersGo
- Updated script example for voltage monitoringGo
- Updated description for reading GPIO status when set as output and
added GPIO Configuration tableGo
- Added information for enabling Forward Channel GPIO using
FC_GPIO_ENGo
- Updated GPIO Output Control
section description for enabling register
0x0EGo
- Added typical latency to Forward Channel GPIO Typical Timing
tableGo
- Updated Clocking Mode table with additional modes, frequency
clarifications, and CSI-2 bandwidth clarificationsGo
- Go
- Go
- Corrected effect of setting M value in register
0x06Go
- Added max and min readings to Voltage Sensor Thresholds description
in Register 0x19 Go
- Updated SENSOR_V1_THRESH description to match SENSOR_V0_THRESH in
register 0x1A Go
- Changed "GPIO0 Sensor" to "Internal Temperature Sensor" in register
0x57Go
- V3LINK_RX_ID changed to V3LINK_TX_ID in register
0xF0-0xF5Go
- Removed IL and RL values from Suggested Components for a "4G"
V3Link PoC Network TableGo
- Changed PoC network impedance recommendation from 2 kΩ to 1
kΩGo
- Updated PoC descriptionGo
- Changed PDB capacitor value to "> 10 μF"Go
- Changed PDB capacitor value from 1-μF to 10-μFGo
Changes from Revision * (April 2021) to Revision A (May 2021)
- 使用可搜索文本和布局更新了图像Go
- removed manual
packageGo