SWRU473A February   2017  – August 2018 CC3120MOD , CC3220MOD , CC3220MODA , CC3220R , CC3220S , CC3220SF

 

  1.   SimpleLinkrep%#8482; Wi-Fi® CC3220 Out-of-Box Application
    1.     Trademarks
    2. 1 Introduction
    3. 2 Download and Installation
    4. 3 Installation for Basic Users
      1. 3.1 UniFlash
      2. 3.2 SimpleLink™ Wi-Fi® Starter Pro Mobile Application
      3. 3.3 Serial Terminal
      4. 3.4 XDS110 Driver Installation
    5. 4 Building the Setup
    6. 5 Flashing the Out-of-Box Project
    7. 6 Getting Started With the OOB Demonstration
      1. 6.1 Connecting to the CC3220
        1. 6.1.1 CC3220 Provisioning
        2. 6.1.2 CC3220 as AP
      2. 6.2 Browse Onboard Website
        1. 6.2.1 Local Network Demo
        2. 6.2.2 OTA Update
        3. 6.2.3 Advanced Settings
      3. 6.3 Using the Mobile Application
        1. 6.3.1 Connect to the CC3220
        2. 6.3.2 Local Network Demo
        3. 6.3.3 OTA Update
          1. 6.3.3.1 Local OTA When CC3220 is in AP Mode
      4. 6.4 Returning to Factory Image
    8. 7 Troubleshooting
      1. 7.1 Red LED Legend
      2. 7.2 Extra Debugging
      3. 7.3 Terminal Messages
    9. 8 Limitations and Known Issues
    10. 9 Out-of-Box for Advance Users
      1. 9.1 Installations for Advance Users
        1. 9.1.1 CC3220 Software Development Kit (SDK)
        2. 9.1.2 Service Pack
        3. 9.1.3 CCS IDE
          1. 9.1.3.1 Add CCS Support for FreeRTOSv9
          2. 9.1.3.2 Product Settings Verification
      2. 9.2 Source Files Briefly Explained
      3. 9.3 Building the OOB Project Using CCS
        1. 9.3.1 Executing in Debug Mode
        2. 9.3.2 Program a User Modified OOB Binary
  2.   Revision History

4 Building the Setup

The following components are required.

  • CC3220 LaunchPad flashed with the OOB package, and correctly set jumpers. See Figure 9 when powering from the USB.
  • Mobile or tablet device with the SimpleLink Wi-Fi Starter Pro application installed. Alternatively, any mobile, tablet, or PC running a web browser can be used.
  • Internet connection is required for the OTA procedure, because the software package is retrieved from the cloud.
  • PC connected to the CC3220 LaunchPad if a terminal emulator is desired (it enables better visibility of the device state and debugging capabilities). In this setup, the PC powers the LaunchPad
  • Local AP

To power up the CC3220 LaunchPad, connect it to the PC or any USB power supply. Out of the box, the CC3220 LaunchPad already contains the application, so there is no need to flash it, therefore the instructions in Section 5 are not required.

CC3220_jumper_setting.pngFigure 9. CC3220 Default Jumpers Setting
mod_lp-jumpers.pngFigure 10. MOD LaunchPad Jumper Settings