ZHCSDS3C May 2015 – April 2018 ADS52J90
PRODUCTION DATA.
| 15 | 14 | 13 | 12 | 11 | 10 | 9 | 8 |
| 0 | LVDS_RATE_
2X |
0 | 0 | 0 | 0 | 0 | 0 |
| R/W-0h | R/W-0h | R/W-0h | R/W-0h | R/W-0h | R/W-0h | R/W-0h | R/W-0h |
| 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
| SEL_CH[2] | EN_JESD | DIS_LVDS | SEL_CH[1] | 0 | SEL_CH[0] | 0 | GLOBAL_PDN |
| R/W-0h | R/W-0h | R/W-0h | R/W-0h | R/W-0h | R/W-0h | R/W-0h | R/W-0h |
| LEGEND: R/W = Read/Write; -n = value after reset |
| Bit | Field | Type | Reset | Description |
|---|---|---|---|---|
| 15 | 0 | R/W | 0h | Must write 0 |
| 14 | LVDS_RATE_2X | R/W | 0h | 0 = 1X rate; normal operation (default)
1 = 2X rate. This setting combines the data of two LVDS pairs into a single LVDS pair. This feature can be used when the ADC clock rate is low. |
| 13-8 | 0 | R/W | 0h | Must write 0 |
| 7 | SEL_CH[2] | R/W | 0h | Input mode selection bit 3. Table 49 lists bit settings for the three input modes. |
| 6 | EN_JESD | R/W | 0h | 0 = JESD interface disabled
1 = JESD interface enabled; see Table 49 |
| 5 | DIS_LVDS | R/W | 0h | 0 = LVDS interface is enabled (default)
1 = LVDS interface is disabled |
| 4 | SEL_CH[1] | R/W | 0h | Input mode selection bit 2. Table 49 lists bit settings for the three input modes. |
| 3 | 0 | R/W | 0h | Must write 0 |
| 2 | SEL_CH[0] | R/W | 0h | Input mode selection bit 1. Table 49 lists bit settings for the three input modes. |
| 1 | 0 | R/W | 0h | Must write 0 |
| 0 | GLOBAL_PDN | R/W | 0h | 0 = The device operates in normal mode (default)
1 = ADC enters complete power-down mode |
| INPUT MODE | SEL_CH[2] | SEL_CH[1] | SEL_CH[0] |
|---|---|---|---|
| 8-channel input | 1 | 1 | 1 |
| 16-channel input | 0 | 1 | 1 |
| 32-channel input | 0 | 0 | 0 |