SLWU079D March   2012  – April 2016

 

  1.   TSW140x High Speed Data Capture/Pattern Generator Card
    1.     Trademarks
    2. 1 Functionality
      1. 1.1 ADC EVM Data Capture
      2. 1.2 DAC EVM Pattern Generator
    3. 2 Hardware Configuration
      1. 2.1 Power Connections
        1. 2.1.1 Output Power Regulators
      2. 2.2 Switches, Jumpers and Fuses
        1. 2.2.1 Switches and Pushbuttons
        2. 2.2.2 Jumpers
        3. 2.2.3 Fuses
      3. 2.3 LEDs
      4. 2.4 Connectors
        1. 2.4.1 Input LVDS ADC Interface Connector
        2. 2.4.2 JTAG Connector
        3. 2.4.3 Input CMOS ADC Interface Connector
        4. 2.4.4 Output LVDS Connector
        5. 2.4.5 Output CMOS DAC Interface Connector
        6. 2.4.6 USB I/O Connection
    4. 3 Software Start up
      1. 3.1 Installation Instructions
      2. 3.2 USB Interface and Drivers
      3. 3.3 Device ini Files
    5. 4 ADC Data Capture Software Operation
      1. 4.1 Testing a TSW1400 EVM with an ADS5281 EVM
      2. 4.2 Testing a TSW1400EVM with an ADS62P49EVM (CMOS Interface)
    6. 5 TSW1400 Pattern Generator Operation
      1. 5.1 Testing a TSW1400 EVM with a DAC3152 EVM
      2. 5.2 Loading DAC Firmware
      3. 5.3 Configuring TSW1400 for Pattern Generation
      4. 5.4 Testing a TSW1400 EVM with a DAC5688EVM (CMOS Interface)
    7. 6 TSW1405 Functional Description
      1. 6.1 Hardware Description
        1. 6.1.1 Power Connections
        2. 6.1.2 Pushbuttons
        3. 6.1.3 Jumpers
        4. 6.1.4 LEDs
      2. 6.2 Software Operation
        1. 6.2.1 Channel Selection
    8. 7 TSW1406 Functional Description
      1. 7.1 Hardware Description
        1. 7.1.1 Power Connections
        2. 7.1.2 Pushbuttons
        3. 7.1.3 Jumpers
        4. 7.1.4 LEDs
      2. 7.2 Software Operation
    9. 8 Revision History

Pushbuttons

The TSW1405 has provisions for two pushbutton switches which are normally not installed. SW1 causes the FPGA to load its bit file from the on-board SPI Flash EEPROM. Since the EEPROM is normally not installed, the pushbutton switch SW1 is normally not installed. Pushbutton switch SW2 is reserved for possible future use, so it is also not installed at present.