SLWU079D March   2012  – April 2016

 

  1.   TSW140x High Speed Data Capture/Pattern Generator Card
    1.     Trademarks
    2. 1 Functionality
      1. 1.1 ADC EVM Data Capture
      2. 1.2 DAC EVM Pattern Generator
    3. 2 Hardware Configuration
      1. 2.1 Power Connections
        1. 2.1.1 Output Power Regulators
      2. 2.2 Switches, Jumpers and Fuses
        1. 2.2.1 Switches and Pushbuttons
        2. 2.2.2 Jumpers
        3. 2.2.3 Fuses
      3. 2.3 LEDs
      4. 2.4 Connectors
        1. 2.4.1 Input LVDS ADC Interface Connector
        2. 2.4.2 JTAG Connector
        3. 2.4.3 Input CMOS ADC Interface Connector
        4. 2.4.4 Output LVDS Connector
        5. 2.4.5 Output CMOS DAC Interface Connector
        6. 2.4.6 USB I/O Connection
    4. 3 Software Start up
      1. 3.1 Installation Instructions
      2. 3.2 USB Interface and Drivers
      3. 3.3 Device ini Files
    5. 4 ADC Data Capture Software Operation
      1. 4.1 Testing a TSW1400 EVM with an ADS5281 EVM
      2. 4.2 Testing a TSW1400EVM with an ADS62P49EVM (CMOS Interface)
    6. 5 TSW1400 Pattern Generator Operation
      1. 5.1 Testing a TSW1400 EVM with a DAC3152 EVM
      2. 5.2 Loading DAC Firmware
      3. 5.3 Configuring TSW1400 for Pattern Generation
      4. 5.4 Testing a TSW1400 EVM with a DAC5688EVM (CMOS Interface)
    7. 6 TSW1405 Functional Description
      1. 6.1 Hardware Description
        1. 6.1.1 Power Connections
        2. 6.1.2 Pushbuttons
        3. 6.1.3 Jumpers
        4. 6.1.4 LEDs
      2. 6.2 Software Operation
        1. 6.2.1 Channel Selection
    8. 7 TSW1406 Functional Description
      1. 7.1 Hardware Description
        1. 7.1.1 Power Connections
        2. 7.1.2 Pushbuttons
        3. 7.1.3 Jumpers
        4. 7.1.4 LEDs
      2. 7.2 Software Operation
    9. 8 Revision History

2.2.3 Fuses

Fuse F1 is in line with the EVM input power. This is used along with diode D14 to protect the board from surges and over voltage on the input power supply.

Fuse F2, when installed, will provide 6 VDC to the DAC EVM interface connector J4.

CAUTION

When using this 6 VDC for a DAC EVM, make sure the DAC EVM power connection is removed.