When creating a new
system design with an Ethernet PHY, follow this schematic
capture procedure:
- Select
desired PHY hardware configurations in table Table 7-31.
- Use the
Electrical Characteristics table, the Table 7-29 table and the Table 7-30 table to select the correct external bootstrap
resistors.
- If using
LEDs, verify the correct external circuit is
applied as shown in Figure 7-27.
- Select an
appropriate clock source that adheres to either
the CMOS-level oscillator or crystal resonator
requirements within the Electrical Characteristics
table.
- Select a
CMC, a list of recommended CMCs are located in
Table 9-2.
- Add
common-mode termination, DC-blocking capacitors,
an MDI-coupling capacitor, and an ESD shunt found
in Table 9-1.
- Confirm that there is sufficient supply
decoupling on VDDIO and VDDA supply pins.
- Add an
external pullup resistor (tie to VDDIO) on MDIO
line.
- If
operating with SGMII, place 0.1μF, DC-blocking
capacitors between the MAC and PHY SGMII
pins.
- If sleep
modes are not desired, WAKE pin must be tied to
VSLEEP directly or through an external pullup
resistor.
Adhere to the following layout procedure:
- Locate
the PHY near the edge of the board so that short
MDI traces can be routed to the desired
connector.
- Place the
MDI external components: CMC, DC-blocking
capacitors, CM termination, MDI-coupling
capacitor, and ESD shunt.
- Create
metal pour keepout under the CMC on the top layer
and at least one layer beneath the top later.
- Confirm that the MDI TRD_M and TRD_P traces are
routed such that the traces are 100Ω differential.
- Place the
clock source near the XI and XO pins.
- Confirm that when configured for MII, RMII, or
RGMII operation, the xMII pins are routed 50Ω and are single-ended with reference to
ground.
- Confirm that transmit path xMII pins are routed
such that setup and hold timing does not violate the PHY requirements.
- Confirm that receive path xMII pins are routed
such that setup and hold timing does not violate the MAC requirements.
- Confirm that when configured for SGMII operation,
the xMII RX_P, RX_M, TX_P, and TX_M pins are routed 100Ω differential.
- Place the
MDIO pullup close to the PHY.