ZHCSLM6A december 2021 – june 2023 TDP0604
PRODUCTION DATA
When standby state is enabled, the TDP0604 waits for a signal on IN_CLK (SWAP disabled) or IN_D2 (SWAP enabled) and is fully functional when a signal is detected. If no signal is detected, then the device reenters standby state waiting for a signal again. In the standby state all of the TMDS outputs are in high-Z status. In both pin-strap mode and I2C mode, standby is enabled by default. In I2C mode, standby can be disabled by setting the STANDBY_DISABLE register.