SLVK228 October   2025 TPS7H1121-SEP

 

  1.   1
  2.   TPS7H1121-SEP Single-Event Effects (SEE)
  3.   Trademarks
  4. 1 Introduction
  5. 2 Single-Event Effects (SEE)
  6. 3 Device and Test Board Information
    1. 3.1 Device and Test Board Information Continued
  7. 4 Irradiation Facility and Setup
  8. 5 LETEFF and Range Calculation
  9. 6 Test Setup and Procedures
  10. 7 Destructive Single-Event Effects (DSEE)
    1. 7.1 Single-Event Latch-up (SEL) Results
    2. 7.2 Single-Event Burnout (SEB) and Single-Event Gate Rupture (SEGR) Results
  11. 8 Single-Event Transients (SET)
  12. 9 Event Rate Calculations
  13. 10Summary
  14.   A References

Single-Event Transients (SET)

SETs are defined as heavy-ion induced transients on VOUT, PG, or SS of the TPS7H1121-SEP.

The species used for SEL testing were Silver (109Ag at 15 MeV/nucleon and 19.5 MeV/nucleon at TAMU and KSEE, respectively). For both ions an incident angle of 0° was used to achieve an LETEFF = 48MeV·cm2/mg (for more details refer to Table 5-1). The kinetic energy in the vacuum for 109Ag is 1.633 GeV and 2.123 GeV for TAMU and KSEE, respectively. A flux of 1.02 × 105 to 1.31 × 104 ions/cm2/s and fluence of 107 ions/cm2 per run were used for the SET characterization discussed in this chapter. Over the course of testing three devices, not a single transient or SEFI was recorded on any of the monitored signals indicating that the TPS7H1121-SEP is SET/SEFI free up to LETEFF = 48 MeV·cm2/mg.

Waveform size, sample rate, trigger type, value, and signal for all scopes used is presented on Table 8-1.

Table 8-1 Scope Settings

Scope Model

Trigger Signal

Trigger Type

Trigger Value

Record Length

Sample Rate

PXIe-5172 (1)

VOUT

Window±3%

100k

100MS/s

PXIe-5172 (2)

PG

Edge/Negative

50%

100k

100MS/s

PXIe-5172 (3)

SS

Edge/Negative

50%

100k

100MS/s

Table 8-2 Summary of TPS7H1121-SEP SET Test Condition and Results
Run

Number

Unit

Number

Facility

ION

LETEFF (MeV·cm2/mg)

VIN (V)

FLUX (ions/cm2/s)Fluence (ions/cm2)VOUT SET ≥ |3%| (#)PG

SET (#)

SS

SET (#)

28

10

TAMU

109Ag

47.7

5

1.31 × 1051.00 × 107

0

0

0

29

12

1.25 × 1051.00 × 107

0

0

0

30

11

TAMU

109Ag47.7

5

1.08 × 1051.00 × 107

0

0

0

31

12

1.10 × 1051.00 × 107

0

0

0

32

12

KSEE109Ag

48

5

1.04 × 1051.00 × 107

0

0

0

33

12

1.02 × 1051.00 × 107

0

0

0