15 Revision History
Changes from Revision B (November 2021) to Revision C (May 2022)
- Described effects of ADC saturationGo
- Corrected
the
VREF1 value used in calculations Go
- Clarified
the
requirement to send
RESET_PASSQ()
Go
- Clarified units for ADC counts. Corrected names of pin raw counts
entries.Go
- Corrected VREF1 voltage level and associated calculations Go
- Added
the instruction to do a full reset to clear
PFsGo
- Updated
descriptionGo
- Clarified
the
requirement to first transition from SEALED mode to UNSEALED
mode before transitioning to FULLACCESS mode Go
- Removed the
PF_RESET()
subcommand, which is no longer recommended for use.Go
- Updated bit descriptions Go
- Removed the
PF_RESET()
subcommand, which is no longer recommended for use.Go
Changes from Revision A (May 2021) to Revision B (November 2021)
Changes from Revision * (January 2021) to Revision A (May 2021)
- Clarified
reserved bitsGo
- Updated
addresses of cell voltage commandsGo
- Clarified the measurement loop slowdown featureGo
- Updated
the description of units for ADC countsGo
- Updated the description of the units for ADC counts Go
- Modified
the
CC Gain
formula. Changed "CC Offset" to
"Board
Offset"Go
- Removed reference to zero delay settingGo
- Updated
the description of the timing of cell open wire
checksGo
- Expanded description of MANU_DATA()
subcommand.Go
- Deleted
information
about disabling FETs using commandsGo
- Added a FET turn-on timing descriptionGo
- Detailed
settings for Wake Comparator speedGo
- Updated the subcommand usage in UNSEALED and
FULLACCESS modes and the
Auto Shutdown Time
operation descriptionsGo
- Clarified delays associated with commands and subcommands, and
updated terminologyGo
- Updated terminologyGo
- Updated the command/subcommand timing table, as well as
terminologyGo
- Updated terminologyGo
- Updated the
CB_ACTIVE_CELLS()
timing
description,
added more details associated with cell
balancing.Go
- Changed reserved bits to WK_SPD
bitsGo