TIDT193 August   2020  – MONTH 

 

  1.   Description
  2. 1Test Prerequisites
    1. 1.1 Voltage and Current Requirements
    2. 1.2 Required Equipment
  3. 2Testing and Results
    1. 2.1 Thermal Images
    2. 2.2 Efficiency and Power Dissipation graphs
    3. 2.3 Efficiency and Power Dissipation Data
    4. 2.4 Voltage Regulation
  4. 3Waveforms
    1. 3.1 Start-up
    2. 3.2 Switch Node
    3. 3.3 Output Voltage Ripple
    4. 3.4 Load Transients
    5. 3.5 Short-Circuit Recovery Response
    6. 3.6 Input Voltage Transient Response

Description

This non-isolated buck converter provides a fixed output of 14V at 130mA for BMS applications. It operates over an input voltage range of 18Vdc – 144Vdc after a startup greater than 23V. Operating in Discontinuous Conduction Mode (DCM), this converter utilizes the UCC28730 controller, which is referenced to the switch node. It offers high efficiency and low cost in a compact form factor.

GUID-20200728-CA0I-MFMT-QMZJ-KFVNSZH1NQJV-low.jpgFigure 1-1 This figure shows the top of the board on the top, and the bottom of the board on the bottom..