SLVUCC2 October   2021 MCT8316A

 

  1.   Trademarks
  2. 1Introduction
    1. 1.1 Hardware Setup
      1. 1.1.1 Jumper Configuration
      2. 1.1.2 External Connections
  3. 2Quick Tuning
  4. 3Comprehensive Tuning
    1. 3.1 Cycle by cycle current limit
      1. 3.1.1 Selecting ILIMIT Pin Resistor
    2. 3.2 Motor Startup Settings
      1. 3.2.1 Motor Startup Profile
      2. 3.2.2 Motor startup method
        1. 3.2.2.1 Initial Position detect (IPD)
        2. 3.2.2.2 Double align
      3. 3.2.3 Selecting RMP_1 and RMP_2 Pin Resistors
    3. 3.3 Abnormal Speed Threshold
      1. 3.3.1 Selecting CONFIG_3 Pin Resistor
    4. 3.4 PWM Switching Frequency
      1. 3.4.1 Selecting CONFIG_1 Pin Resistor
    5. 3.5 Lead Angle
      1. 3.5.1 Steps to Tune Lead Angle
      2. 3.5.2 Selecting LDANGLE pin resistor
    6. 3.6 Slew Rate and Buck Voltage
      1. 3.6.1 Selecting SLEW_RATE Pin Resistor
  5. 4Revision History

3.3.1 Selecting CONFIG_3 Pin Resistor

Refer to Table 3-13 to select the appropriate CONFIG_3 resistor value based on the Abnormal speed threshold. If the calculated abnormal speed threshold does not match the values listed in Table 3-13, pick a value that is greater than the calculated value.

Table 3-13 CONFIG_3 Pin Resistor Values
Abnormal Speed Threshold (Hz) CONFIG_3 Pin Resistor Value

1000

 Tie to GND

2000

 30 kΩ, ±5%

3000

 91 kΩ, ±5%

4000

 300 kΩ, ±5%