SLVUBZ2A September   2020  – December 2020 LM5127-Q1

 

  1.   Trademarks
  2. 1Introduction
    1. 1.1 Applications
    2. 1.2 Features
  3. 2EVM Setup
    1. 2.1 EVM Characteristics
  4. 3EVM Photo
  5. 4Testing Procedures
    1. 4.1 EVM Connectors and Test Points
  6. 5Test Results
    1. 5.1 Efficiency
    2. 5.2 Thermal Performance
    3. 5.3 Steady State
    4. 5.4 Load Transient
    5. 5.5 Line Transient Responses
  7. 6Schematics, PCB Layers, and Bill of Materials
    1. 6.1 Schematics
    2. 6.2 PCB Layers
    3. 6.3 Bill of Materials
  8. 7EVM Modifications
    1. 7.1 Configure Channel 1 as a Buck Controller
      1. 7.1.1 Component Modifications
      2. 7.1.2 CFG/MODE Pin Selection
    2. 7.2 Configure Channel 2 and Channel 3 as a Dual Phase Buck Controller
      1. 7.2.1 Component Modifications
      2. 7.2.2 CFG/MODE Pin Selection
    3. 7.3 EVM Modification Test Setups
  9. 8Revision History

Configure Channel 2 and Channel 3 as a Dual Phase Buck Controller

Section 7.2 describes how to configure channel 2 and channel 3 as a dual phase interleaved buck controller. Figure 7-2 and Figure 7-3 show the typical applications when channel 2 and channel 3 is configured as a dual phase buck controller.

GUID-20201214-CA0I-F3DB-RQF9-44H6JB8786DP-low.gif Figure 7-2 Channel 1 as a Boost, Channel 2 and Channel 3 as Dual Phase Buck Controller
GUID-20201215-CA0I-X7N4-WM9S-BVTKFH68LLP7-low.gif Figure 7-3 Channel 1 as a Buck, Channel 2 and Channel 3 as a Dual Phase Buck Controller