SLUUCM7 October   2022 TPS563300

 

  1.   TPS563300EVM-226 3-A, Regulator Evaluation Module
  2.   Trademarks
  3. 1Introduction
  4. 2Performance Specification Summary
  5. 3Modifications
    1. 3.1 Output Voltage Setpoint
  6. 4Test Setup and Results
    1. 4.1 Input and Output Connections
    2. 4.2 Start-Up Procedure
    3. 4.3 Load Transient Response
    4. 4.4 Output Voltage Ripple
    5. 4.5 Start-Up
    6. 4.6 Shutdown
  7. 5Board Layout
    1. 5.1 Layout
  8. 6Schematic and List of Materials
    1. 6.1 Schematic
    2. 6.2 List of Materials

5.1 Layout

The board layout for the TPS563300EVM is shown in Figure 5-1, Figure 5-2, and Figure 5-3. The top layer contains the main power traces for VIN, VOUT, and ground. Also on the top layer are connections for the pins of the TPS563300 and a large area filled with ground. Most of the signal traces are also located on the top side. The input decoupling capacitors, C6, C7, C8, and C9 are located as close to the IC as possible. The input and output connectors, test points, and all of the components are located on the top side. The bottom layer is a ground plane along with the switching node copper fill, signal ground copper fill and the feed back trace from the point of regulation to the top of the resistor divider network. Both the top layer and bottom layer use 2 oz copper thickness.

Figure 5-4 and Figure 5-5 are the TPS563300EVM board top view and bottom view, respectively.

Figure 5-1 TPS563300EVM Top Assembly
Figure 5-2 TPS563300EVM Top Layer
Figure 5-3 TPS563300EVM Bottom Layer
Figure 5-4 TPS563300EVM Board Top View
Figure 5-5 TPS563300EVM Board Bottom View