SPRUI25D June   2015  – March 2019 TMS320F28374S , TMS320F28375S , TMS320F28375S-Q1 , TMS320F28376S , TMS320F28377S , TMS320F28377S-Q1 , TMS320F28379S

 

  1.   LAUNCHXL-F28377S overview
    1.     Trademarks
    2. 1 Introduction
    3. 2 Kit Contents
      1. 2.1 Revisions
    4. 3 Installation
      1. 3.1 Code Composer Studio
        1. 3.1.1 Download the Required Software
        2. 3.1.2 Install the Software
        3. 3.1.3 Install the Hardware
    5. 4 Getting Started with the LAUNCHXL-F28377S
      1. 4.1 Getting Started
      2. 4.2 Demo Application, ADC Sampling
      3. 4.3 Program and Debug the ADC Sample Demo Application
      4. 4.4 Using other Examples
    6. 5 Hardware Configuration
      1. 5.1 ADC Resolution
      2. 5.2 Power Domain
      3. 5.3 Boot Mode Selection
      4. 5.4 Connecting a BoosterPack
      5. 5.5 Device Migration Path
    7. 6 LAUNCHXL-F28377S Hardware
      1. 6.1 Device Pin Out
      2. 6.2 Schematics
      3. 6.3 PCB Layout
      4. 6.4 Bill of Materials (BOM)
    8. 7 References
    9. 8 Frequently Asked Questions (FAQ)
  2.   Revision History

2.1 Revisions

The first production revision of the LAUNCHXL-F28377S in 2016 was Revision 1.0.

All Revisions:

  • Resistor R7 in the oscillator circuit is incorrectly placed or should not be installed. This resistor may impact startup time or robustness of the clocking circuit over the full operating range of the MCU or different physical layouts of this circuit. The probability is low that this resistor will have any impact on the functionality of this EVM as is not intended to be operated outside of Standard Temperature and Pressure in a lab or prototype environment. Do not use this circuit as reference. Follow the requirements for the Oscillator schematic as documented in the MCU Datasheet.