SLVUCA1 November   2021 TPS7H1210-SEP

 

  1.   Trademarks
  2. 1Introduction
    1. 1.1 Features
    2. 1.2 Applications
  3. 2Setup
    1. 2.1 Input/Output Connectors and Jumper Descriptions
      1. 2.1.1 J1, J4 (–)VIN
      2. 2.1.2 J6 GND
      3. 2.1.3 J2, J5 (–)VOUT
      4. 2.1.4 J7 GND
      5. 2.1.5 J3 EN
      6. 2.1.6 TP1-5 Test Points
    2. 2.2 Equipment Setup
  4. 3Operation
  5. 4Adjustable Operation
  6. 5Test Results
    1. 5.1 Enable, Disable, and Soft Start Timing
    2. 5.2 Output Load Transients
    3. 5.3 PSRR
    4. 5.4 Noise Spectral Density
  7. 6Board Layout
  8. 7Schematic and Bill of Materials

5.4 Noise Spectral Density

Figure 5-5 shows the typical noise spectral density (NSD) performance of the TPS7H1210EVM operating with the following conditions: VIN = –6 V, VOUT = –5 V, ILOAD = 1 A.

10-Hz to 100-kHz integrated RMS noise VN = 27.2 µVRMS.

Figure 5-5 TPS7H1210EVM NSD