DLPU027D August   2014  – March 2019 DLP2010 , DLPA2005 , DLPC3430 , DLPC3435

 

  1.   DLP LightCrafter display 2010 EVM user’s guide
    1.     Trademarks
    2. 1 DLP® LightCrafter™ Display 2010 PCB Overview
    3. 2 Applicable Documents
    4. 3 What is in the LightCrafter Display 2010 EVM?
    5. 4 Light Engine
    6. 5 Quick-Start Procedure
    7. 6 Circuit Description
      1. 6.1 Connectors, Switch and Push buttons on Main Board
      2. 6.2 Connectors on DLP LightCrafter™ Display board
    8. 7 EVM Setup
  2.   Revision History

1 DLP® LightCrafter™ Display 2010 PCB Overview

DLPDLCR2010EVM-PCB is the PCB-only version of the DLP LightCrafter Display 2010 evaluation module (EVM). This EVM only includes the drive electronics for the DLP2010 DMD without any optical module. This EVM can be used for integrating your choice of DLP2010 DMD based optical module using proper flex cable for DMD interface and LED interface (please refer to  the schematics for pinout and layout information). Typically the flash memory (which stores the firmware) is part of the optical engine, and therefore DLPDLCR2010EVM-PCB does not have the flash memory installed. If you would like to install the flash memory, please refer the DLPC3435 datasheet (DLPS038) for flash memory requirements and recommend flash memory.

DLP3010 DLPA2005 DLPC3435 PCB.jpgFigure 2. DLP LightCrafter Display PCB

In addition to this document, see Section 2 for more information.