SWRA465A August   2014  – July 2015 CC2530 , CC2530 , CC2530-RF4CE , CC2530-RF4CE , CC2592 , CC2592

 

  1.   Using CC2592 Front End With CC2530
    1.     Trademarks
    2. 1  Introduction
    3. 2  Acronyms Used in This Documents
    4. 3  Absolute Maximum Ratings
    5. 4  Electrical Specifications
      1. 4.1 Operating Conditions
      2. 4.2 Current Consumption
      3. 4.3 Receive Parameters
      4. 4.4 Received Signal Strength Indicator (RSSI)
      5. 4.5 Transmit Parameters
      6. 4.6 Output Power Programming
      7. 4.7 Typical Performance Curves
      8. 4.8 IEEE - Transmit Power Spectral Density (PSD) Mask
    6. 5  Application Circuit
      1. 5.1 Power Decoupling
      2. 5.2 Input /Output Matching and Filtering
      3. 5.3 Bias Resistor
      4. 5.4 Antenna Considerations
    7. 6  PCB Layout Considerations
      1. 6.1 The Gain of the CC2592
    8. 7  Regulatory Requirements
      1. 7.1 Compliance of FCC Part 15.247 When Using the CC2530 With the CC2592
    9. 8  Controlling the CC2592
    10. 9  Integrating CC2592 With Z-Stack and TIMAC
    11. 10 References
  2.   A Marker - Delta Method
    1.     A.1
  3.   Revision History

4.2 Current Consumption

TC = 25°C, VDD = 3.0 V, f = 2440 MHz if nothing else is stated. All parameters are measured on the SimpleLink™ ZigBee® Network Range Extender Reference Design[3] with a 50 Ω load.

Table 2. Current Consumption

Parameter Condition Typical Unit
Receive Current Wait for sync, -90 dBm input level
Wait for sync, -50 dBm input level 		28.8
25 		mA
Transmit Current TXPOWER = 0xF5
TXPOWER = 0xE5
TXPOWER = 0xD5
TXPOWER = 0xC5
TXPOWER = 0xB5
TXPOWER = 0xA5
TXPOWER = 0x95
TXPOWER = 0x85
TXPOWER = 0x75
TXPOWER = 0x65
TXPOWER = 0x55
TXPOWER = 0x45
TXPOWER = 0x35 		172.3
155.7
143.1
133.8
124.8
115.2
102.7
95.0
847.5
82.3
77.9
75.1
73.6 		mA