SLUUAQ0C October   2013  – November 2021

 

  1.   Trademarks
  2. 1 Introduction
  3. 2 Description
    1. 2.1 Typical Applications
    2. 2.2 Features
  4. 3 Electrical Performance Specifications
  5. 4 Schematic
  6. 5 Test Setup
    1. 5.1 Test Equipment
    2. 5.2 Recommended Test Setup
      1. 5.2.1 Input Connections
      2. 5.2.2 Output Connections
  7. 6 Configurations
    1. 6.1 Switching Frequency Selection
    2. 6.2 Mode Selection
    3. 6.3 VDD Pin Supply Selection
  8. 7 Test Procedure
    1. 7.1 Line/Load Regulation and Efficiency Measurement Procedure
    2. 7.2 Control Loop Gain and Phase Measurement Procedure
    3. 7.3 List of Test Points
    4. 7.4 Equipment Shutdown
  9. 8 EVM Assembly Drawing and PCB Layout
  10. 9 List of Materials
  11. 10Revision History

7.3 List of Test Points

Table 7-1 Test Point Functions
TEST POINTSNAMEDESCRIPTION
TP1VINConverter input supply voltage
TP2VREGLDO voltage
TP3PGoodPower good output
TP4PGNDPower ground
TP5CHBInput B for loop injection
TP6SWSwitching node
TP7VOUTVOUT terminal +
TP8CHAInput A for loop injection
TP9PGNDPower ground
TP10RFRF pin
TP11TRIPTRIP pin
TP12ENEnable pin
TP13VDDVDD pin
TP14MODEMode pin
TP15AGNDAnalog ground