4 修订历史记录
Changes from B Revision (January 2014) to C Revision
-
已添加 ESD 额定值表,特性 说明部分,器件功能模式,应用和实施部分,电源相关建议部分,布局部分,器件和文档支持部分以及机械、封装和可订购信息部分 Go
-
更改了特性分类等级Go
-
将器件信息表中的“封装尺寸”列由 3.67mm x 3.67mm 更改为 7.00mm x 7.00mmGo
-
Corrected UART sections that are addressed with CSA and CSB in the Pin Functions tableGo
-
Corrected the channel interrupt names for INTA and INTAB in the Pin Functions tableGo
-
Corrected UART channels for RTSA and RTSB in the Pin Functions tableGo
-
Corrected UART sections that are addressed with CSA and CSB in the Pin Functions tableGo
-
Corrected the channel interrupt names for INTA and INTAB in the Pin Functions tableGo
-
Corrected UART channels for RTSA and RTSB in the Pin Functions tableGo
-
Combined Recommended Operating Conditions tables and updated min and max values for VI, VIH, and VILGo
-
Changed the VCC low-level input voltage MAX value From: 0.3 x VCC To: 0.8 V in the Recommended Operating Conditions tableGo
-
Combined Electrical Characteristics tablesGo
-
Changed Test Conditions for ICC in the Electrical Characteristics VCC = 1.8 V tableGo
-
Changed the VOL MAX value From: 0.4 V To: 0.5 V in the Electrical Characteristics VCC = 5 V tableGo
-
Changed Figure 14 Go
-
Changed (216-1) To: (216-1) in the Programmable Baud Rate Generator section Go
-
Changed the FIFO RDY note in Figure 26 Go
-
Deleted RX FIFO D status, RX FIFO C status, TX FIFO D status and TX FIFO C status from Address 111 in Table 7Go
-
Changed table note (8) from "CS A-D" to "CS A-B"Go
-
Changed BIT 3 in Table 11 from "IRQ(A-D)" to "IRQ(A-B)" Go
-
Changed Figure 27 Go
Changes from A Revision (August 2009) to B Revision
-
Thermal Information tableGo
-
Replaced the register map table with Figure 26Go
-
Updated Table 7Go