TIDUES6 August   2020  – MONTH 

 

  1.   Description
  2.   Resources
  3.   Features
  4.   Applications
  5.   5
  6. 1System Description
    1. 1.1 Key System Specifications
  7. 2System Overview
    1. 2.1 Block Diagram
    2. 2.2 Design Considerations
    3. 2.3 Highlighted Products
      1. 2.3.1 DRV8906-Q1
      2. 2.3.2 DRV8873-Q1
      3. 2.3.3 TPS1HB16-Q1
      4. 2.3.4 LM2904B-Q1
      5. 2.3.5 TLIN1028-Q1
    4. 2.4 System Design Theory
      1. 2.4.1 Mirror XY and LED Driver
      2. 2.4.2 Mirror Fold Driver
      3. 2.4.3 Mirror Heater Driver for Defogging and De-icing
      4. 2.4.4 Electrochromic Mirror Driver
        1. 2.4.4.1 Sallen-Key Low-Pass Filter
        2. 2.4.4.2 High-Current Buffer Amplifier
        3. 2.4.4.3 Buffer Amplifier Stability for Very-Large Capacitive Loads
        4. 2.4.4.4 Fast Discharge of Large Capacitive Load
      5. 2.4.5 SBC - LIN Communication Interface and System Supply
  8. 3Hardware, Software, Testing Requirements, and Test Results
    1. 3.1 Required Hardware and Software
      1. 3.1.1 Hardware
    2. 3.2 Testing and Results
      1. 3.2.1 Test Setup
      2. 3.2.2 Test Results
        1. 3.2.2.1 Reverse Battery Protection
        2. 3.2.2.2 X&Y Motors and LED Driver
        3. 3.2.2.3 Thermal Performance
  9. 4Design Files
    1. 4.1 Schematics
    2. 4.2 Bill of Materials
    3. 4.3 Altium Project
    4. 4.4 Gerber Files
    5. 4.5 Assembly Drawings
  10. 5Software Files
  11. 6Related Documentation
    1. 6.1 Trademarks
    2. 6.2 Third-Party Products Disclaimer
  12. 7Terminology

2.4.5 SBC - LIN Communication Interface and System Supply

The TLIN1028-Q1 is used for the LIN communication interface due to its wide operating ranges and protection features that it provides; such as ESD protection, undervoltage protection, DTO protection, and thermal protection. All these protection features ensure that the LIN transceiver operates normally without damaging itself or other components.

The local decoupling capacitors (C20 and C21) and the LDO output capacitors (C18 and C19) are chosen based on the recommendations given on the data sheet. The data sheet recommends a 200-pF capacitor between the LIN pin and ground for slave applications. C4 is chosen to be 220 pF for filtering noise from the LIN signal. The 10-kΩ resistor (R20) is used as a pullup resistor from the RXD pin to 3.3 V. R21 is used to limit the input current to the device and C26 is used to filter noise.

GUID-4C0DBE76-469F-457A-8121-B0169A633755-low.pngFigure 2-13 TLIN1028-Q1