SLUUC76B November   2019  – April 2021 TPS566231

 

  1.   Trademarks
  2. 1Introduction
  3. 2Performance Specification Summary
  4. 3Output Voltage Setpoint
  5. 4Test Setup and Results
    1. 4.1 Input/Output Connections
    2. 4.2 Start-Up Procedure
    3. 4.3 Start-Up
    4. 4.4 Shut-Down
    5. 4.5 Output Voltage Ripple
  6. 5Board Layout
    1. 5.1 Layout
  7. 6Board Profile, Schematic, and List of Materials
    1. 6.1 Board Profile
    2. 6.2 Schematic
    3. 6.3 List of Materials
  8. 7References
  9. 8Revision History

Input/Output Connections

The TPS566231EVM is provided with input/output connectors and test points as shown in Table 4-1. A power supply capable of supplying 6 A must be connected to J1 through a pair of 20-AWG wires. The load must be connected to J2 through a pair of 20-AWG wires. The maximum load current capability is 6 A. Wire lengths must be minimized to reduce losses in the wires. Test point TP2 provides a place to monitor the VIN input voltages with TP7 providing a convenient ground reference. TP5 is used to monitor the output voltage with TP13 as the ground reference.

Table 4-1 Connection and Test Points
Reference
Designator
Function
J1VIN (see Table 1-1 for VIN range)
J2VOUT, 1V at 6-A maximum
JP1Two resistor dividers connected to VIN to enable EN.
JP2En Control, short pin1 and pin2 to make EN High, short pin2 and pin3 to make EN low.
TP1VIN positive monitor point
TP2VIN positive monitor point
TP3Switch node test point
TP4VOUT positive monitor point
TP5VOUT positive monitor point
TP6GND monitor test point
TP7GND monitor test point
TP8VCC monitor test point
TP9EN Test point
TP10GND monitor test point
TP11Loop test point
TP12GND monitor test point
TP13GND monitor test point