After pressing "Configure" within the ADC35xx GUI perform the following steps to setup HSDC pro:

• Launch HSDC Pro

• Select the TSW1400 and click OK

• Click OK for the no firmware loaded prompt.

• Select “ADC3660_2W_16bit_CMOS.ini” to load firmware, and click Yes.

Figure 4-9 Real Decimation HSDC Pro INI File.

• Click on the cog next to “ADC Output Data Rate”.

Figure 4-10 HSDC Pro Cog Wheel.

• In the new dialogue box, enter 65M in “ADC Sampling Rate”

• Enter 1M in “ADC Input Frequency”

• Enter 16 in “Decimation”.

• Click Ok.

Figure 4-11 Real Decimation Mode HSDC Pro Parameters.

• Click the Capture button

• In order to adjust the noise floor, from -130 dBFs to -150 dBFs by clicking on -130 and entering -150 before pressing enter. You should see the noise floor adjusted.

Figure 4-12 Real Decimation Noise Floor at -130 dBFs.

Figure 4-13 Real Decimation Noise Floor at -150 dBFs.