SLVUC16 October   2020 TLC6C5748-Q1

 

  1.   Trademarks
  2. 1Introduction
    1. 1.1 Features
    2. 1.2 Applications
  3. 2Test Setup
    1. 2.1 The TLC6C5748EVM Kit
    2. 2.2 System/Equipment Requirements
    3. 2.3 Software Setup
    4. 2.4 Hardware Setup
    5. 2.5 Test Procedure
  4. 3Configuration of MCU Launchpad
  5. 4TLC6C5748EVM Board Layout
  6. 5TLC6C5748EVM Schematic
  7. 6TLC6C5748EVM Bill of Materials
  8. 7Revision History

2.4 Hardware Setup

Connect the computer, DC power supply, MSP-EXP432P401 Launchpad and TLC6C5748EVM as shown in Figure 2-6.

GUID-20201022-CA0I-FV6R-KDF8-WLRCLDR1FZ5D-low.gif Figure 2-6 TLC6C5748EVM Hardware Setup

The detailed steps are listed as follows.

Step 1: With the 12-V DC power supply disconnected from the TLC6C5748EVM, set the DC power supply to 7.5-V DC. Set current limit to 3 A.

Step 2: Use banana to clip test leads to connect the DC power supply between the VLED and GND terminals on TLC6C5748EVM board.

Step 3: EVM testing requires MSP-EXP432P401 Launchpad, which can be ordered from TI store. Plug MSP-EXP432P401 Launchpad into TLC6C5748EVM using BoosterPack Headers in the direction as shown in Figure 2-7.

GUID-20201022-CA0I-RN0J-PW8Q-5VFNFJM1KRBG-low.gif Figure 2-7 The direction of BoosterPack

Step 4: The Launchpad is connected to the PC as shown in Figure 2-8 using the Micro USB cable provided in Launchpad kit.

GUID-20201022-CA0I-39DK-LB7J-BWZQN2TXV1KF-low.gif Figure 2-8 Connect MCU Launchpad to PC