SN74CBTLV3857
- Enable Signal Is SSTL_2 Compatible
- Flow-Through Architecture Optimizes PCB Layout
- Designed for Use With 200 Mbit/s Double Data-Rate (DDR) SDRAM Applications
- Switch On-State Resistance Is Designed to Eliminate Series Resistor to DDR SDRAM
- Internal 10-k
Pulldown Resistors to Ground on B Port - Internal 50-k Pullup Resistor on Output-Enable Input
- Rail-to-Rail Switching on Data I/O Ports
- Ioff Supports Partial-Power-Down Mode Operation
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
This 10-bit FET bus switch is designed for 3-V to 3.6-V VCC operation and SSTL_2 output-enable (OE\) input levels.
When OE\ is low, the 10-bit bus switch is on, and port A is connected to port B. When OE\ is high, the switch is open, and
the high-impedance state exists between the two ports. There are 10-k pulldown resistors
to ground on the B port.
The FET switch on-state resistance is designed to replace the series terminating resistor in the SSTL_2 data path.
This device is fully specified for partial-power-down applications using Ioff. The Ioff feature ensures that damaging current will not backflow through the device when it is powered down. The device has isolation during power off.
技術文件
| 重要文件 | 類型 | 標題 | 格式選項 | 下載最新的英文版本 | 日期 | |
|---|---|---|---|---|---|---|
| * | 資料表 | SN74CBTLV3857 datasheet (Rev. E) | 2003/10/13 | |||
| 應用說明 | Selecting the Correct Texas Instruments Signal Switch (Rev. E) | PDF | HTML | 2022/6/2 | |||
| 應用說明 | Multiplexers and Signal Switches Glossary (Rev. B) | PDF | HTML | 2021/12/1 | |||
| Application brief | Eliminate Power Sequencing with Powered-off Protection Signal Switches (Rev. C) | PDF | HTML | 2021/1/6 |
設計與開發
如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。
LEADED-ADAPTER1 — 適用於快速測試 TI 的 5、8、10、16 及 24 針腳引線封裝的表面貼裝至 DIP 接頭適配器
EVM-LEADED1 板可用於快速測試和搭建 TI 常見的有引腳封裝 此電路板具備板上配置，可將 TI 的 D、DBQ、DCT、DCU、DDF、DGS、DGV 和 PW 表面黏著封裝轉換為 100mil DIP 排針。
| 封裝 | 針腳 | CAD 符號、佔位空間與 3D 模型 |
|---|---|---|
| SOIC (DW) | 24 | Ultra Librarian |