SCES415O
November 2002 – November 2026
SN74LVC1G58
PRODUCTION DATA
1
1
Features
2
Applications
3
Description
4
Pin Configuration and Functions
5
Specifications
5.1
Absolute Maximum Ratings
5.2
ESD Ratings
5.3
Recommended Operating Conditions
5.4
Thermal Information
5.5
Electrical Characteristics
5.6
Switching Characteristics
5.7
Switching Characteristics
5.8
Operating Characteristics
5.9
Typical Characteristics
6
Parameter Measurement Information
7
Detailed Description
7.1
Overview
7.2
Functional Block Diagram
7.3
Feature Description
7.3.1
Balanced CMOS Push-Pull Outputs
7.3.2
CMOS Schmitt-trigger Inputs
7.3.3
Partial Power Down (Ioff)
7.3.4
Clamp Diode Structure
7.3.5
Over-Voltage Tolerant Inputs
7.4
Device Functional Modes
8
Application and Implementation
8.1
Application Information
8.2
Typical Application
8.2.1
Design Requirements
8.2.1.1
Power Considerations
8.2.1.2
Input Considerations
8.2.1.3
Output Considerations
8.2.2
Detailed Design Procedure
8.2.3
Application Curve
8.3
Power Supply Recommendations
8.4
Layout
8.4.1
Layout Guidelines
8.4.2
Layout Example
9
Device and Documentation Support
9.1
Documentation Support
9.1.1
Related Documentation
9.2
Receiving Notification of Documentation Updates
9.3
Support Resources
9.4
Trademarks
9.5
Electrostatic Discharge Caution
9.6
Glossary
10
Revision History
11
Mechanical, Packaging, and Orderable Information
封装选项
机械数据 (封装 | 引脚)
DRY|6
MPDS221F
DSF|6
MPDS301G
YZP|6
MXBG347
DCK|6
MPDS114F
DRL|6
MPDS159I
DBV|6
MPDS026Q
散热焊盘机械数据 (封装 | 引脚)
DRY|6
QFND138E
订购信息
sces415o_oa
sces415o_pm
8.4.1
Layout Guidelines
Bypass capacitor placement
Place near the positive supply terminal of the device
Provide an electrically short ground return path
Use wide traces to minimize impedance
Keep the device, capacitors, and traces on the same side of the board whenever possible
Signal trace geometry
8mil to 12mil trace width
Lengths less than 12cm to minimize transmission line effects
Avoid 90° corners for signal traces
Use an unbroken ground plane below signal traces
Flood fill areas around signal traces with ground
Parallel traces must be separated by at least 3x dielectric thickness
For traces longer than 12cm
Use impedance controlled traces
Source-terminate using a series damping resistor near the output
Avoid branches; buffer each signal that must branch separately