ZHCSJ37 December 2018 OPA2313-Q1
PRODUCTION DATA.
6.8 Typical Characteristics
At TA = 25°C, VS = 5 V, RL = 10 kΩ connected to VS / 2, and VCM = VOUT = VS / 2, unless otherwise noted.
Figure 1. Open-Loop Gain and Phase vs Frequency 
Figure 3. Quiescent Current vs Supply 
Figure 5. Offset Voltage Production Distribution 
Figure 7. Offset Voltage vs Common-Mode Voltage 
Figure 9. CMRR and PSRR vs Frequency
(Referred-to-Input)
Figure 11. 0.1-Hz to 10-Hz Input Voltage Noise 
Figure 13. Voltage Noise vs Common-Mode Voltage 
Figure 15. Open-Loop Output Impedance vs Frequency 
Figure 17. Output Voltage Swing vs Output Current (Over Temperature) 
Figure 19. Closed-Loop Gain vs Frequency
(Maximum Supply)
Figure 21. Phase Margin vs Capacitive Load 
Figure 23. Small-Signal Pulse Response
(Maximum Supply)
Figure 25. Large-Signal Pulse Response
(Maximum Supply)
Figure 27. Negative Overload Recovery 
Figure 29. Channel Separation vs Frequency 
Figure 31. THD+N vs Output Amplitude
(Maximum Supply)
Figure 33. EMIRR IN+ vs Frequency 
Figure 2. Open-Loop Gain vs Temperature 
Figure 4. Quiescent Current vs Temperature 
Figure 6. Offset Voltage Drift Distribution 
Figure 8. Offset Voltage vs Temperature 
Figure 10. CMRR and PSRR vs Temperature 
Figure 12. Input Voltage Noise Spectral Density vs Frequency 
Figure 14. Input Bias and Offset Current vs Temperature 
Figure 16. Maximum Output Voltage vs Frequency and Supply Voltage 
Figure 18. Closed-Loop Gain vs Frequency (Minimum Supply) 
Figure 20. Small-Signal Overshoot vs
Load Capacitance
Figure 22. Small-Signal Pulse Response
(Minimum Supply)
Figure 24. Large-Signal Pulse Response
(Minimum Supply)
Figure 26. Positive Overload Recovery 
Figure 28. No Phase Reversal 
Figure 30. THD+N vs Output Amplitude
(Minimum Supply)
Figure 32. THD+N vs Frequency