ZHCSTS6K December   2003  – November 2023 SN74AVC8T245

PRODUCTION DATA  

  1.   1
  2. 特性
  3. 应用
  4. 说明
  5. Pin Configuration and Functions
  6. Specifications
    1. 5.1  Absolute Maximum Ratings
    2. 5.2  ESD Ratings
    3. 5.3  Recommended Operating Conditions
    4. 5.4  Thermal Information
    5. 5.5  Electrical Characteristics
    6. 5.6  Switching Characteristics, VCCA = 1.2 V
    7. 5.7  Switching Characteristics, VCCA = 1.5 V ± 0.1 V
    8. 5.8  Switching Characteristics, VCCA = 1.8 V ± 0.15 V
    9. 5.9  Switching Characteristics, VCCA = 2.5 V ± 0.2 V
    10. 5.10 Switching Characteristics, VCCA = 3.3 V ± 0.3 V
    11. 5.11 Operating Characteristics
    12. 5.12 Typical Total Static Power Consumption (ICCA + ICCB)
    13. 5.13 Typical Characteristics
  7.   Parameter Measurement Information
  8. Detailed Description
    1. 6.1 Overview
    2. 6.2 Functional Block Diagram
    3. 6.3 Feature Description
      1. 6.3.1 Fully Configurable Dual-Rail Design
      2. 6.3.2 Support High-Speed Translation
      3. 6.3.3 Ioff Supports Partial-Power-Down Mode Operation
      4. 6.3.4 Balanced High-Drive CMOS Push-Pull Outputs
      5. 6.3.5 Vcc Isolation
    4. 6.4 Device Functional Modes
  9. Application and Implementation
    1. 7.1 Application Information
    2. 7.2 Typical Application
      1. 7.2.1 Design Requirements
      2. 7.2.2 Detailed Design Procedure
      3. 7.2.3 Application Curve
    3. 7.3 Power Supply Recommendations
    4. 7.4 Layout
      1. 7.4.1 Layout Guidelines
      2. 7.4.2 Layout Example
  10. Device and Documentation Support
    1. 8.1 Documentation Support
      1. 8.1.1 Related Documentation
    2. 8.2 接收文档更新通知
    3. 8.3 支持资源
    4. 8.4 Trademarks
    5. 8.5 静电放电警告
    6. 8.6 术语表
  11. Revision History
  12. 10Mechanical, Packaging, and Orderable Information

Layout Guidelines

For device reliability, follow common printed-circuit board layout guidelines such as:

  • Use bypass capacitors on power supplies.
  • Use short trace lengths to avoid excessive loading.
  • Place pads on the signal paths for loading capacitors or pullup resistors to adjust the signals rise and fall times, depending on the system requirements.