SWRU585 November   2021 IWR6843

 

  1.   Trademarks
  2. 1Getting Started
    1. 1.1 Key Features
    2. 1.2 Kit Contents
    3. 1.3 mmWave Out of Box Demo
  3. 2Hardware
    1. 2.1 Block Diagram
  4. 3PCB Storage and Handling Recommendations
    1. 3.1 PCB Storage and Handling Recommendations
    2. 3.2 Higher Power Demanding Applications
  5. 4IWR6843LEVM Antenna
    1. 4.1 Transmitter and Receiver Virtual Array
  6. 5Hardware Details
    1. 5.1  Switch Settings
    2. 5.2  LEDs
    3. 5.3  Connectors
    4. 5.4  USB Connector
    5. 5.5  DCA1000 HD Connector
    6. 5.6  MMWAVEICBOOST HD Connector
    7. 5.7  CANFD Connector
    8. 5.8  I2C Connections
    9. 5.9  EEPROM
    10. 5.10 Default I2C Address
    11. 5.11 Modular Mode
    12. 5.12 Flashing the Board
    13. 5.13 DCA1000EVM Mode
    14. 5.14 MMWAVEICBOOST Mode
    15. 5.15 Raw ADC Data Capture Using MMWAVEICBOOST and DCA1000 EVMs
    16. 5.16 Muxing Scheme
  7. 6Software, Development Tools, and Example Code
  8. 7TI E2E Community
  9. 8References

5.2 LEDs

Table 5-2 contains the list of LEDs on the IWR6843LEVM.

Table 5-2 List of LEDs
Reference Designator Color Usage Comment
D3 Orange Power good This LED is used to indicate the PGOOD. If this LED is glowing, it means that all of the voltage rails are in limits.
D4 Green USB enumeration LED Turns on while enumerating the USB
D5 Green Reset Toggles when reset button is depressed
D6 Green 5 V indicator Indicates the application of 5 V power
D7 Green GPIO 2 Connected to GPIO2 can be used when GPIO is set as an output.