首頁 電源管理 電源保護開關與控制器 eFuse（整合式熱插拔）
首頁
電源管理
電源保護開關與控制器
eFuse（整合式熱插拔）

TPS25200-Q1

現行

2.5V 至 6.5V、67mΩ、2.1-2.7A 車用 eFuse，關閉時具反向電流阻斷

立即訂購
產品規格表

TPS25200-Q1

現行
產品規格表 立即訂購

產品詳細資料

Vabsmax_cont (V) 20 Vin (max) (V) 6.5 Vin (min) (V) 2.5 Current limit (max) (A) 2.7 Current limit (min) (A) 0.083 Features Fault output, Overcurrent protection, Overvoltage protection, Reverse current blocking when off, Short-circuit protection, Soft-start, Thermal shutdown Overcurrent response Current limiting Fault response Latch-off Ron (typ) (mΩ) 67 Overvoltage response Clamp, Cut-off Rating Automotive Soft start Adjustable Quiescent current (Iq) (typ) (A) 0.000147 Quiescent current (Iq) (max) (A) 0.0002 Device type eFuses and hot swap controllers TI functional safety category Functional Safety-Capable Operating temperature range (°C) -40 to 125
Vabsmax_cont (V) 20 Vin (max) (V) 6.5 Vin (min) (V) 2.5 Current limit (max) (A) 2.7 Current limit (min) (A) 0.083 Features Fault output, Overcurrent protection, Overvoltage protection, Reverse current blocking when off, Short-circuit protection, Soft-start, Thermal shutdown Overcurrent response Current limiting Fault response Latch-off Ron (typ) (mΩ) 67 Overvoltage response Clamp, Cut-off Rating Automotive Soft start Adjustable Quiescent current (Iq) (typ) (A) 0.000147 Quiescent current (Iq) (max) (A) 0.0002 Device type eFuses and hot swap controllers TI functional safety category Functional Safety-Capable Operating temperature range (°C) -40 to 125
WSON (DRV) 6 4 mm² (2 mm × 2 mm)
  • Qualified for Automotive Applications
  • AEC-Q100 Qualified With the Following Results:
    • Device HBM Classification Level 2
    • Device CDM Classification Level C5
  • 2.5-V to 6.5-V Operation
  • 20-V Continuous VIN (Absolute Maximum)
  • 7.6-V Input Overvoltage Shutoff
  • 5.25-V to 5.55-V Fixed Overvoltge Clamp
  • 0.6-µs Overvoltage Lockout Response
  • 3.5-µs Short-Circuit Response
  • 67-mΩ High-Side MOSFET
  • Accurate 2.5-A Minimum, 2.9-A Maximum and
    2.1-A Minimum, 2.5-A Maximum Setting (Including
    Resistor)
  • ±6.3% Current-Limit Accuracy at 2.7 A
  • Reverse Current Blocking While Disabled
  • Built-in Soft Start
  • Pin-to-Pin Compatible with TPS2553
  • Qualified for Automotive Applications
  • AEC-Q100 Qualified With the Following Results:
    • Device HBM Classification Level 2
    • Device CDM Classification Level C5
  • 2.5-V to 6.5-V Operation
  • 20-V Continuous VIN (Absolute Maximum)
  • 7.6-V Input Overvoltage Shutoff
  • 5.25-V to 5.55-V Fixed Overvoltge Clamp
  • 0.6-µs Overvoltage Lockout Response
  • 3.5-µs Short-Circuit Response
  • 67-mΩ High-Side MOSFET
  • Accurate 2.5-A Minimum, 2.9-A Maximum and
    2.1-A Minimum, 2.5-A Maximum Setting (Including
    Resistor)
  • ±6.3% Current-Limit Accuracy at 2.7 A
  • Reverse Current Blocking While Disabled
  • Built-in Soft Start
  • Pin-to-Pin Compatible with TPS2553

The TPS25200-Q1 device is a 5-V eFuse with a precision current-limit and overvoltage clamp. The device provides robust protection for load and source during overvoltage and overcurrent events.

The TPS25200-Q1 device is an intelligent protected load-switch with a VIN value tolerant to 20 V. In the event that an incorrect voltage is applied at the IN pin, the output clamps to 5.4 V to protect the load. If the voltage at the IN pin exceeds 7.6 V, the device disconnects the load to prevent damage to the device, load, or both.

The TPS25200-Q1 device has an internal 67-mΩ power switch and is intended for protecting the source, device, and load under a variety of abnormal conditions. The device provides up to 2.4 A of continuous load current. The current-limit is programmable from 85 mA to 2.7 A with a single resistor to ground. During overload events, the output current is limited to the level set by the RILIM resistor. If a persistent overload occurs, the device eventually enters thermal shutoff to prevent damage to the TPS25200-Q1 device.

The TPS25200-Q1 device is a 5-V eFuse with a precision current-limit and overvoltage clamp. The device provides robust protection for load and source during overvoltage and overcurrent events.

The TPS25200-Q1 device is an intelligent protected load-switch with a VIN value tolerant to 20 V. In the event that an incorrect voltage is applied at the IN pin, the output clamps to 5.4 V to protect the load. If the voltage at the IN pin exceeds 7.6 V, the device disconnects the load to prevent damage to the device, load, or both.

The TPS25200-Q1 device has an internal 67-mΩ power switch and is intended for protecting the source, device, and load under a variety of abnormal conditions. The device provides up to 2.4 A of continuous load current. The current-limit is programmable from 85 mA to 2.7 A with a single resistor to ground. During overload events, the output current is limited to the level set by the RILIM resistor. If a persistent overload occurs, the device eventually enters thermal shutoff to prevent damage to the TPS25200-Q1 device.
filter 尋找其它 eFuse（整合式熱插拔）
下載 觀看有字幕稿的影片 影片

技術文件

找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 7
重要文件 類型 標題 格式選項 下載最新的英文版本 日期
* 資料表 TPS25200-Q1 5-V eFuse With Precision Adjustable Current Limit and Overvoltage Clamp datasheet PDF | HTML 2015/3/9
應用說明 How To Drive Resistive, Inductive, Capacitive, and Lighting Loads (Rev. E) PDF | HTML 2021/3/9
功能安全資訊 簡化汽車及工業領域的功 能安全認證 Download English Version 2020/6/9
功能安全資訊 eFuse: Safety Certification and why it Matters 2020/3/18
功能安全資訊 TPS25200-Q1 Functional Safety FIT Rate and Failure Mode Distribution 2019/12/19
應用說明 Basics of eFuses (Rev. A) 2018/4/5
應用說明 Power Multiplexing Using Load Switches and eFuses (Rev. A) 2017/6/20

設計與開發

如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。

開發板

TPS25200EVM-618 — 具有輸入過電壓保護的 TPS25200EVM-618 可調整電流限制配電開關

TPS25200EVM-618 具備可調整限流配電開關，並具有輸入過電壓保護與輸出過電壓箝位功能。該 EVM 為使用者提供便利的測試點、連接器與各種指示燈，以便對 TPS25200 進行全面評估。

使用指南: PDF
支援產品和硬體
有庫存
限制：
??asset.out-of-stock-ti_zh_TW??
無法提供
模擬型號

TPS25200 Unencrypted PSpice Transient Model Package (Rev. A)

SLVMA73A.ZIP (41 KB) - PSpice 模型
支援產品和硬體
計算工具

TVS-RECOMMENDATION-CALC — TVS diode recommendation tool

This tool suggests suitable TVS for given system parameters and abs max voltage rating of the device.
支援產品和硬體
封裝 針腳 CAD 符號、佔位空間與 3D 模型
WSON (DRV) 6 Ultra Librarian
適用 TI 的評估品項標準條款與條件。

訂購與品質

建議產品可能具有與此 TI 產品相關的參數、評估模組或參考設計。

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

以英文檢視所有論壇主題

內容係由 TI 和社群貢獻者依「現狀」提供，且不構成 TI 規範。檢視使用條款。

若有關於品質、封裝或訂購 TI 產品的問題，請參閱 TI 支援。​​​​​​​​​​​​​​

影片