首頁 電源管理 DC/DC 切換穩壓器 DC/DC 控制器

LM51770-Q1

現行

80V 大範圍 VIN 雙向 4 開關降壓升壓控制器

產品詳細資料

Rating Automotive Topology Buck-Boost Vin (max) (V) 78 Vout (max) (V) 78 Vout (min) (V) 3.3 Features 1% reference, Adjustable current limit, Adjustable soft start, Adjustable switching frequency, Advanced power saving, Bidirectional, Current monitoring, Enable, Forced PWM, Frequency synchronization, Hiccup mode protection, Light Load Efficiency Mode, Pass-through mode, Power good, Tracking, adjustable UVLO EMI features Frequency Dithering, Spread Spectrum Duty cycle (max) (%) 100 TI functional safety category Functional Safety-Capable Operating temperature range (°C) -40 to 150
Rating Automotive Topology Buck-Boost Vin (max) (V) 78 Vout (max) (V) 78 Vout (min) (V) 3.3 Features 1% reference, Adjustable current limit, Adjustable soft start, Adjustable switching frequency, Advanced power saving, Bidirectional, Current monitoring, Enable, Forced PWM, Frequency synchronization, Hiccup mode protection, Light Load Efficiency Mode, Pass-through mode, Power good, Tracking, adjustable UVLO EMI features Frequency Dithering, Spread Spectrum Duty cycle (max) (%) 100 TI functional safety category Functional Safety-Capable Operating temperature range (°C) -40 to 150
HTSSOP (DCP) 38 62.08 mm² (9.7 mm × 6.4 mm)
  • Wide input range from 3.5V to 80V (85V absolute maximum)
    • Minimum 2.8V when V(BIAS) > 3.5V
  • Output voltage from 3.3V to 78V
  • Low shutdown IQ of 3µA
  • Low operating IQ of 60µA
  • 3% reverse current limit accuracy for precise charging currents
  • Average input and output current monitor or limiter
  • Dynamic output voltage tracking for PWM or analog input signals
  • Power save mode (PSM) selectable for high light load efficiency
  • Two integrated high-voltage supply LDOs with automatic selection
  • 2A peak current logic level gate driver with integrated bootstrap diode and bootstrap voltage protections
  • Fixed frequency across all operating modes (boost, buck-boost, buck)
    • Forced PWM mode selectable
    • Switching up to 2MHz for small solution and component size
    • External clock synchronization
  • Spread spectrum operation selectable
  • Adjustable undervoltage protection
  • Hiccup overcurrent and short protection
  • AEC-Q100 qualified for automotive applications
    • Test temperature grade 1: –40°C to +150°C
  • Functional Safety-Capable
  • Wide input range from 3.5V to 80V (85V absolute maximum)
    • Minimum 2.8V when V(BIAS) > 3.5V
  • Output voltage from 3.3V to 78V
  • Low shutdown IQ of 3µA
  • Low operating IQ of 60µA
  • 3% reverse current limit accuracy for precise charging currents
  • Average input and output current monitor or limiter
  • Dynamic output voltage tracking for PWM or analog input signals
  • Power save mode (PSM) selectable for high light load efficiency
  • Two integrated high-voltage supply LDOs with automatic selection
  • 2A peak current logic level gate driver with integrated bootstrap diode and bootstrap voltage protections
  • Fixed frequency across all operating modes (boost, buck-boost, buck)
    • Forced PWM mode selectable
    • Switching up to 2MHz for small solution and component size
    • External clock synchronization
  • Spread spectrum operation selectable
  • Adjustable undervoltage protection
  • Hiccup overcurrent and short protection
  • AEC-Q100 qualified for automotive applications
    • Test temperature grade 1: –40°C to +150°C
  • Functional Safety-Capable

The LM51770-Q1 is a four switch buck-boost controller. The device provides a regulated output voltage if the input voltage is higher, equal, or lower than the adjusted output voltage. In power save mode, the device supports high efficiency with low output loads due to its low quiescence currents. In power save mode, the device supports high efficiency close to 99% efficiency over the full range of the output current. The LM51770-Q1 runs at a fixed switching frequency, which is set through the RT or SYNC pin. The switching frequency remains the same during buck, boost, and buck-boost operation. The integrated and optional average current monitor helps monitor and limit input and output current of the LM51770-Q1. This feature also supports charging backup power elements, like batteries or capacitors, with constant current (CC) and constant voltage (CV).

The LM51770-Q1 is a four switch buck-boost controller. The device provides a regulated output voltage if the input voltage is higher, equal, or lower than the adjusted output voltage. In power save mode, the device supports high efficiency with low output loads due to its low quiescence currents. In power save mode, the device supports high efficiency close to 99% efficiency over the full range of the output current. The LM51770-Q1 runs at a fixed switching frequency, which is set through the RT or SYNC pin. The switching frequency remains the same during buck, boost, and buck-boost operation. The integrated and optional average current monitor helps monitor and limit input and output current of the LM51770-Q1. This feature also supports charging backup power elements, like batteries or capacitors, with constant current (CC) and constant voltage (CV).

下載 觀看有字幕稿的影片 影片

技術文件

找不到結果。請清除您的搜尋條件,然後再試一次。
檢視所有 3
重要文件 類型 標題 格式選項 下載最新的英文版本 日期
* 資料表 LM51770-Q1 80V Wide VIN Bidirectional 4-Switch Buck-Boost Controller datasheet PDF | HTML 2025/9/9
功能安全資訊 LM51770-Q1 Functional Safety FIT Rate and FMD PDF | HTML 2025/7/15
應用說明 Layout Optimization of 4-Switch Buck-Boost Converters PDF | HTML 2023/9/5

設計與開發

如需其他條款或必要資源,請按一下下方的任何標題以檢視詳細頁面 (如有)。

開發板

LM51770EVM-HV — LM51770 降壓升壓控制器評估模組

LM51770EVM-HV 評估模組 (EVM) 展示使用 LM51770 的靈活高功率降壓升壓設計。EVM 設定為在 36V 至 48V 輸入電壓範圍內運作,並且提供最高 4A 負載電流的穩壓 48V 輸出。EVM 在切換頻率為 380kHz 下運作。此裝置的大多數設定皆可透過跨接器進行調整或設定,例如:操作模式(PSM 或 fPWM)、偏壓電源和外部時鐘同步。
使用指南: PDF | HTML
支援產品和硬體
有庫存
限制:
??asset.out-of-stock-ti_zh_TW??
無法提供
開發板

LM5177EVM-HP — 具四開關降壓升壓控制器的 LM5177 評估模組

LM5177EVM-HP 展示使用 LM5177 wide-vin 降壓升壓控制器的靈活高功率降壓升壓設計。評估模組設定為在 4.2 V 至 36 V 輸入電壓範圍內運作,並提供最高 9.4 A 負載電流的穩壓 16-V 輸出。
使用指南: PDF | HTML
支援產品和硬體
有庫存
限制:
??asset.out-of-stock-ti_zh_TW??
無法提供
計算工具

LM51770-QUICKSTART-CALC — LM51770x BuckBoost Quickstart Calculator Tool

LM51770 BuckBoost Quickstart Calculator Tool. This standalone tool facilitates and assists the power supply engineer with the design of a DC/DC buck-boost converter based on the LM51770.
支援產品和硬體
封裝 針腳 CAD 符號、佔位空間與 3D 模型
HTSSOP (DCP) 38 Ultra Librarian

訂購與品質

建議產品可能具有與此 TI 產品相關的參數、評估模組或參考設計。

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

內容係由 TI 和社群貢獻者依「現狀」提供,且不構成 TI 規範。檢視使用條款

若有關於品質、封裝或訂購 TI 產品的問題,請參閱 TI 支援。​​​​​​​​​​​​​​

影片