전력 관리 AC/DC 스위칭 레귤레이터 AC/DC 컨트롤러

UC1825-SP

활성

Radiation-tolerant, QML-V, 30V input, 1.5A dual-output 1MHz PWM controller

이 제품의 최신 버전이 있습니다

open-in-new 대안 비교
비교 대상 장치와 동일한 기능을 지원하는 핀 대 핀.
UC1825B-SP 활성 Radiation-hardened, QML-V, 30V input, 2A dual-output 1MHz PWM controller Improved TID performance (100 krad) with increased max frequency (1 MHz) and dual outputs for half/full-bridge, or push-pull topologies.

제품 상세 정보

Topology Boost, Flyback, Forward, Full bridge, Half bridge, Push pull Control mode Current Features Error amplifier, Multi-topology, Soft start, Synchronization pin Duty cycle (max) (%) 80
Topology Boost, Flyback, Forward, Full bridge, Half bridge, Push pull Control mode Current Features Error amplifier, Multi-topology, Soft start, Synchronization pin Duty cycle (max) (%) 80
LCCC (FK) 20 79.0321 mm² (— mm × — mm) CDIP (J) 16 135.3552 mm² (— mm × — mm)
  • QML-V Qualified, SMD 5962-87681
  • Rad-Tolerant: 30 kRad (Si) TID(1)
  • Compatible With Voltage- or Current-Mode Topologies
  • Practical Operation Switching Frequencies to 1 MHz
  • 50-ns Propagation Delay-to-Output
  • High-Current Dual Totem Pole Outputs (1.5 A Peak)
  • Wide Bandwidth Error Amplifier
  • Fully Latched Logic With Double-Pulse Suppression
  • Pulse-by-Pulse Current Limiting
  • Soft Start/Maximum Duty-Cycle Control
  • Undervoltage Lockout With Hysteresis
  • Low Start-Up Current (1.1 mA)

(1) Radiation tolerance is a typical value based upon initial device qualification with dose rate = 10 mrad/sec. Radiation Lot Acceptance Testing is available - contact factory for details.

  • QML-V Qualified, SMD 5962-87681
  • Rad-Tolerant: 30 kRad (Si) TID(1)
  • Compatible With Voltage- or Current-Mode Topologies
  • Practical Operation Switching Frequencies to 1 MHz
  • 50-ns Propagation Delay-to-Output
  • High-Current Dual Totem Pole Outputs (1.5 A Peak)
  • Wide Bandwidth Error Amplifier
  • Fully Latched Logic With Double-Pulse Suppression
  • Pulse-by-Pulse Current Limiting
  • Soft Start/Maximum Duty-Cycle Control
  • Undervoltage Lockout With Hysteresis
  • Low Start-Up Current (1.1 mA)

(1) Radiation tolerance is a typical value based upon initial device qualification with dose rate = 10 mrad/sec. Radiation Lot Acceptance Testing is available - contact factory for details.

The UC1825 PWM control device is optimized for high-frequency switched mode power supply applications. Particular care was given to minimizing propagation delays through the comparators and logic circuitry while maximizing bandwidth and slew rate of the error amplifier. This controller is designed for use in either current-mode or voltage mode systems with the capability for input voltage feed-forward.

Protection circuitry includes a current limit comparator with a 1-V threshold, a TTL compatible shutdown port, and a soft start pin which will double as a maximum duty-cycle clamp. The logic is fully latched to provide jitter-free operation and prohibit multiple pulses at an output. An undervoltage lockout section with 800 mV of hysteresis assures low start up current. During undervoltage lockout, the outputs are high impedance.

This device features totem pole outputs designed to source and sink high peak currents from capacitive loads, such as the gate of a power MOSFET. The on state is designed as a high level.

The UC1825 PWM control device is optimized for high-frequency switched mode power supply applications. Particular care was given to minimizing propagation delays through the comparators and logic circuitry while maximizing bandwidth and slew rate of the error amplifier. This controller is designed for use in either current-mode or voltage mode systems with the capability for input voltage feed-forward.

Protection circuitry includes a current limit comparator with a 1-V threshold, a TTL compatible shutdown port, and a soft start pin which will double as a maximum duty-cycle clamp. The logic is fully latched to provide jitter-free operation and prohibit multiple pulses at an output. An undervoltage lockout section with 800 mV of hysteresis assures low start up current. During undervoltage lockout, the outputs are high impedance.

This device features totem pole outputs designed to source and sink high peak currents from capacitive loads, such as the gate of a power MOSFET. The on state is designed as a high level.

다운로드 스크립트와 함께 비디오 보기 비디오

관심 가지실만한 유사 제품

open-in-new 대안 비교
비교 대상 장치와 유사한 기능.
TPS7H5001-SP 활성 Radiation-hardened, QML-P and QML-V, 2MHz dual-output PWM controller with synchronous rectification More feature rich QML-qualified radiation-hardened PWM controller family.
TPS7H5005-SEP 활성 Radiation-tolerant, 2MHz, dual-output PWM controller with synchronous rectification More feature rich radiation-tolerant PWM controller family for LEO or shorter duration missions

기술 자료

검색된 결과가 없습니다. 검색어를 지우고 다시 시도하세요.
12개 모두 보기
상위 문서 유형 직함 형식 옵션 최신 영어 버전 다운로드 날짜
* 데이터 시트 High-Speed PWM Controller. datasheet (Rev. A) 2012. 3. 22
* 방사능 및 안정성 보고서 UC1825-SP Radiation Test Report (5962-8768104VEA) 2015. 5. 8
* SMD UC1825-SP SMD 5962-87681 2016. 7. 8
선택 가이드 TI Space Products (Rev. L) 2026. 3. 27
애플리케이션 노트 Hermetic Package Reflow Profiles, Termination Finishes, and Lead Trim and Form (Rev. A) PDF | HTML 2025. 11. 5
애플리케이션 노트 Heavy Ion Orbital Environment Single-Event Effects Estimations (Rev. B) PDF | HTML 2025. 6. 10
추가 자료 TI Engineering Evaluation Units vs. MIL-PRF-38535 QML Class V Processing (Rev. B) 2025. 2. 20
애플리케이션 노트 QML flow, its importance, and obtaining lot information (Rev. C) 2023. 8. 30
애플리케이션 노트 Single-Event Effects Confidence Interval Calculations (Rev. A) PDF | HTML 2022. 10. 19
Application brief Controlling Input Power for Present and Next-Generation Power Controllers PDF | HTML 2020. 12. 14
애플리케이션 노트 DLA Standard Microcircuit Drawings (SMD) and JAN Part Numbers Primer 2020. 8. 21
e북 Radiation Handbook for Electronics (Rev. A) 2019. 5. 21

설계 및 개발

추가 조건 또는 필수 리소스는 사용 가능한 경우 아래 제목을 클릭하여 세부 정보 페이지를 확인하세요.

시뮬레이션 모델

UC1825 TINA-TI Transient Reference Design

SLUM653.TSC (5219 KB) - TINA-TI 레퍼런스 설계
지원되는 제품 및 하드웨어
시뮬레이션 모델

UC1825 Unencrypted TINA-TI Transient Spice Model

SLUM673.ZIP (6 KB) - Tina-TI Spice 모델
지원되는 제품 및 하드웨어
레퍼런스 디자인

PMP22680 — 40W, ±15V 플라이백(자기 피드백 레퍼런스 설계 포함)

이 레퍼런스 설계는 70V ~ 120V DC 입력 전압으로부터 40W에서 절연 ±15V를 생성합니다. 이 설계는 광커플러의 기능을 대체하기 위해 자기 피드백 회로를 사용합니다.
지원되는 제품 및 하드웨어
레퍼런스 디자인

PMP23033 — 자기 피드백을 지원하는 40V 5V 단일 스위치 순방향 컨버터 레퍼런스 설계

이 레퍼런스 설계는 60V~120V DC 입력 전압으로부터 40W에서 절연 5V를 생성합니다. 이 설계는 광커플러의 기능을 대체하기 위해 자기 피드백 회로를 사용합니다.
지원되는 제품 및 하드웨어
패키지 CAD 기호, 풋프린트 및 3D 모델
LCCC (FK) 20 Ultra Librarian
CDIP (J) 16 Ultra Librarian

주문 및 품질

권장 제품에는 본 TI 제품과 관련된 매개 변수, 평가 모듈 또는 레퍼런스 디자인이 있을 수 있습니다.

지원 및 교육

TI 엔지니어의 기술 지원을 받을 수 있는 TI E2E™ 포럼

콘텐츠는 TI 및 커뮤니티 기고자에 의해 "있는 그대로" 제공되며 TI의 사양으로 간주되지 않습니다. 사용 약관을 참조하십시오.

품질, 패키징, TI에서 주문하는 데 대한 질문이 있다면 TI 지원을 방문하세요. ​​​​​​​​​​​​​​

동영상