DRV8301
- 6-V to 60-V Operating Supply Voltage Range
- 1.7-A Source and 2.3-A Sink Gate Drive Current
Capability - Slew Rate Control for EMI Reduction
- Bootstrap Gate Driver With 100% Duty Cycle
Support - 6- or 3-PWM Input Modes
- Dual Integrated Current Shunt Amplifiers With
Adjustable Gain and Offset - Integrated 1.5-A Buck Converter
- 3.3-V and 5-V Interface Support
- SPI
- Protection Features:
- Programmable Dead Time Control (DTC)
- Programmable Overcurrent Protection (OCP)
- PVDD and GVDD Undervoltage Lockout
(UVLO) - GVDD Overvoltage Lockout (OVLO)
- Overtemperature Warning/Shutdown
(OTW/OTS) - Reported Through nFAULT, nOCTW, and SPI
Registers
The DRV8301 is a gate driver IC for three-phase motor drive applications. The device provides three half-bridge drivers, each capable of driving two Nchannel MOSFETs. The DRV8301 supports up to 1.7-A source and 2.3-A peak current capability. The DRV8301 can operate off of a single power supply with a wide range from 6-V to 60-V. The device uses a bootstrap gate driver architecture with trickle charge circuitry to support 100% duty cycle. The DRV8301 uses automatic handshaking when the high-side or low-side MOSFET is switching to prevent flow of current. Integrated VDS sensing of the high-side and low-side MOSFETs is used to protect the external power stage against overcurrent conditions.
The DRV8301 includes two current shunt amplifiers for accurate current measurement. The amplifiers support bidirectional current sensing and provide an adjustable output offset up to 3 V.
The DRV8301 also includes an integrated switching mode buck converter with adjustable output and switching frequency. The buck converter can provide up to 1.5 A to support MCU or additional system power needs.
The SPI provides detailed fault reporting and flexible parameter settings such as gain options for the current shunt amplifiers and slew rate control of the gate drivers.
기술 자료
설계 및 개발
추가 조건 또는 필수 리소스는 사용 가능한 경우 아래 제목을 클릭하여 세부 정보 페이지를 확인하세요.
BOOSTXL-DRV8301 — DRV8301 및 NexFET™ MOSFET을 지원하는 모터 드라이브 부스터팩
The BOOSTXL-DRV8301 is 10A, 3-phase brushless DC drive stage based on the DRV8301 pre-driver and CSD18533Q5A NexFET™ power MOSFET. The module has 3x low side current sense amps (2 internal to DRV8301, 1 external). The module also has a 1.5A step down buck converter, is fully protected with (...)
INSTASPIN-BLDC — InstaSPIN™-BLDC 솔루션
In keeping with TI’s philosophy of making motor control more accessible and easier to use by design engineers, TI is proud to announce the release of its newest motor control technology, InstaSPIN-BLDC. Targeted at low cost BLDC applications, InstaSPIN-BLDC is a sensorless control technique based (...)
TIDM-LPBP-BLDCMOTORDRIVE — 3상 브러시리스 DC 모터 드라이버
3상 브러시리스 DC 모터 드라이버 레퍼런스 설계는 DRV8301 사전 드라이버 및 CSD18533Q5A NextFET™ 파워 MOSFET에 기반한 10A, 3상 브러시리스 DC 구동 스테이지입니다. 이 모듈에는 저압측 전류 감지 증폭기 3개(DRV8301 내부에 2개, 외부에 1개)가 있습니다. 이 설계는 또한 1.5A 스텝다운 컨버터를 활용하며, 합선, 열, 관통 방지로부터 안전하며, SPI 인터페이스를 통해 쉽게 구성할 수 있습니다. 무센서, 브러시리스 제어 기법 및 구동 스테이지 설계에 이상적입니다.
TIDM-THREEPHASE-BLDC-HC-SPI — SPI를 사용한 3상 브러시리스/PMSM 고전류 모터 제어 솔루션
This reference design demonstrates a motor control solution for spinning three-phase brushless DC (BLDC) and brushless AC (BLAC) - often referred to as permanent magnet synchronous (PMSM) - motors featuring the C2000™ Piccolo™ microcontroller and the DRV8301 three-phase motor driver. It (...)
TIDM-THREEPHASE-BLDC-HC-SPI-INST — InstaSPIN 소프트웨어를 사용한 3상 브러시리스/PMSM 고전류 모터 제어 솔루션
이 레퍼런스 설계는 ROM에서 InstaSPIN-FOC 및 InstaSPIN-MOTION을 지원하는 C2000™ Piccolo™ 마이크로컨트롤러와 DRV8301 3상 모터 드라이버를 사용하는 3상 BLDC(브러시리스 DC) 및 BLAC(브러시리스 AC)(흔히 'PMSM(영구 자석 동기화 모터)'이라고 함) 모터를 구동하는 모터 제어 솔루션을 보여줍니다. 이 설계는 N형 MOSFET 2개를 고압측과 저압측에 대해 각각 하나씩 구동할 수 있는 3개의 하프 브리지 드라이버를 제공합니다. 최대 2.3A 싱크 및 (...)
| 패키지 | 핀 | CAD 기호, 풋프린트 및 3D 모델 |
|---|---|---|
| HTSSOP (DCA) | 56 | Ultra Librarian |