主页 电源管理 LED 驱动器 汽车 LED 驱动器
主页
电源管理
LED 驱动器
汽车 LED 驱动器

TPS929121-Q1

正在供货

具有 FlexWire 接口的 12 通道汽车类 40V 高侧 LED 驱动器

立即订购
数据表

TPS929121-Q1

正在供货
数据表 立即订购

产品详情

Number of channels 12 Topology Current Source Rating Automotive TI functional safety category Functional Safety-Capable Operating temperature range (°C) -40 to 125 Vin (min) (V) 4.5 Vin (max) (V) 40 Iout (max) (A) 0.075 Iq (typ) (mA) 10 Features Enable/Shutdown, Fault Detection, Fault Diagnostic, LED Open Detection, LED Short to Ground Detection, LED Weak Supply Diagnostics, PWM Dimming, Reference Resistor Open or Short Detection, Thermal Error Flag, Thermal Prewarning and Shutdown, Thermal shutdown
Number of channels 12 Topology Current Source Rating Automotive TI functional safety category Functional Safety-Capable Operating temperature range (°C) -40 to 125 Vin (min) (V) 4.5 Vin (max) (V) 40 Iout (max) (A) 0.075 Iq (typ) (mA) 10 Features Enable/Shutdown, Fault Detection, Fault Diagnostic, LED Open Detection, LED Short to Ground Detection, LED Weak Supply Diagnostics, PWM Dimming, Reference Resistor Open or Short Detection, Thermal Error Flag, Thermal Prewarning and Shutdown, Thermal shutdown
HTSSOP (PWP) 24 49.92 mm² 7.8 x 6.4
  • AEC-Q100-qualified for automotive applications:
    • Temperature grade 1: –40°C to +125°C, TA
  • 12-channel precision high-side current output:
    • Supply voltage 4.5 V to 40 V
    • Up to 75-mA channel current set by resistor
    • 2-bit global, 6-bit independent current setting
    • High current accuracy < ±5% at 5 mA to 75 mA
    • High current accuracy < ±10% at 1 mA
    • Low voltage drop 500 mV at 50 mA
    • 12-bit independent PWM dimming
    • Programmable PWM frequency up to 20 kHz
    • Linear and exponential dimming method
  • FlexWire control interface
    • Up to 1-MHz clock frequency
    • Maximum 16 devices on one FlexWire bus
    • Up to 8-bytes data transaction in one frame
    • 5-V LDO output to supply CAN transceiver
  • Diagnostic and protection:
    • Programmable fail-safe state
    • LED open-circuit detection
    • LED short-circuit detection
    • Single-LED short-circuit diagnostic
    • Programmable low-supply detection
    • Open-drain ERR for fault indication
    • Watchdog and CRC for FlexWire interface
    • 8-Bit ADC for pin voltage measurement
    • Overtemperature protection
  • AEC-Q100-qualified for automotive applications:
    • Temperature grade 1: –40°C to +125°C, TA
  • 12-channel precision high-side current output:
    • Supply voltage 4.5 V to 40 V
    • Up to 75-mA channel current set by resistor
    • 2-bit global, 6-bit independent current setting
    • High current accuracy < ±5% at 5 mA to 75 mA
    • High current accuracy < ±10% at 1 mA
    • Low voltage drop 500 mV at 50 mA
    • 12-bit independent PWM dimming
    • Programmable PWM frequency up to 20 kHz
    • Linear and exponential dimming method
  • FlexWire control interface
    • Up to 1-MHz clock frequency
    • Maximum 16 devices on one FlexWire bus
    • Up to 8-bytes data transaction in one frame
    • 5-V LDO output to supply CAN transceiver
  • Diagnostic and protection:
    • Programmable fail-safe state
    • LED open-circuit detection
    • LED short-circuit detection
    • Single-LED short-circuit diagnostic
    • Programmable low-supply detection
    • Open-drain ERR for fault indication
    • Watchdog and CRC for FlexWire interface
    • 8-Bit ADC for pin voltage measurement
    • Overtemperature protection

With increasing demand for animation in automotive lighting, LEDs must be controlled independently. Therefore, LED drivers with digital interfaces are essential to effectively drive pixel-controlled lighting applications. In exterior lighting, multiple lamp functions are typically located on different PCB boards with off-board wires connected to each other. It is difficult for a traditional single-ended interface to meet the strict EMC requirements. By using an industrial-standard CAN physical layer, the UART-based FlexWire interface of the TPS929121-Q1 easily accomplishes long distance off-board communication without impacting EMC.

The TPS929121-Q1 is a 12-channel, 40-V high-side LED driver that controls the 8-bit output current and 12-bit PWM duty cycles. The device meets multiple regulation requirements with LED open-circuit, short-to-ground, and single LED short-circuit diagnostics. A configurable watchdog also automatically sets fail-safe states when the MCU connection is lost, and, with programmable EEPROM, TPS929121-Q1 can flexibly be set for different application scenarios.

With increasing demand for animation in automotive lighting, LEDs must be controlled independently. Therefore, LED drivers with digital interfaces are essential to effectively drive pixel-controlled lighting applications. In exterior lighting, multiple lamp functions are typically located on different PCB boards with off-board wires connected to each other. It is difficult for a traditional single-ended interface to meet the strict EMC requirements. By using an industrial-standard CAN physical layer, the UART-based FlexWire interface of the TPS929121-Q1 easily accomplishes long distance off-board communication without impacting EMC.

The TPS929121-Q1 is a 12-channel, 40-V high-side LED driver that controls the 8-bit output current and 12-bit PWM duty cycles. The device meets multiple regulation requirements with LED open-circuit, short-to-ground, and single LED short-circuit diagnostics. A configurable watchdog also automatically sets fail-safe states when the MCU connection is lost, and, with programmable EEPROM, TPS929121-Q1 can flexibly be set for different application scenarios.
open-in-new 查找其他 汽车 LED 驱动器
下载 观看带字幕的视频 视频

您可能感兴趣的相似产品

open-in-new 比较替代产品
功能与比较器件相同且具有相同引脚
TPS929120-Q1 正在供货 具有 FlexWire 接口的 12 通道汽车类 40V 高侧 LED 驱动器 Low-supply detection threshold decreased to 5V

技术文档

star =有关此产品的 TI 精选热门文档
未找到结果。请清除搜索并重试。
查看全部 2
类型 标题 下载最新的英语版本 日期
* 数据表 TPS929121-Q1 12-Channel Automotive 40-V High-Side LED Driver With FlexWire 数据表 (Rev. A) PDF | HTML 2021年 2月 5日
用户指南 TPS929xxx-Q1 示例代码 PDF | HTML 英语版 PDF | HTML 2023年 4月 11日

设计和开发

如需其他信息或资源，请点击以下任一标题进入详情页面查看（如有）。

评估板

TPS929120EVM — TPS929120-Q1 12 通道汽车 LED 驱动器评估模块

TPS929120-Q1 评估模块 (EVM) 可帮助设计人员评估 TPS929120-Q1 的运行和性能，TPS929120-Q1 是一款带有 FlexLED 接口的 12 通道 40V 高侧 LED 驱动器，可独立控制输出电流和 PWM 占空比，适用于汽车照明应用。该评估模块还具有 LED 开路、接地短路和单 LED 短路诊断功能，支持在失去 MCU 连接或没有 MCU 控制时，自动进入预定义的失效防护状态。
用户指南: PDF
查看选项
应用软件和框架

TPS92912XQ1-SW-F5529 — Reference code for TPS92912x-Q1 based on MSP430F5529 (MSP-EXP430F5529LP)

This reference code showcases the ability of the MSP430F5529 device to communicate with the TPS929120-Q1 and TPS929121-Q1 LED driver. The code configures the MCU using UART to drive 12 LEDs which is available on the TPS929120EVM.
lock = 需要出口许可（1 分钟）
支持的产品和硬件

支持的产品和硬件

产品
汽车 LED 驱动器
TPS929120-Q1 — 具有 FlexWire 接口的 12 通道汽车类 40V 高侧 LED 驱动器 TPS929121-Q1 — 具有 FlexWire 接口的 12 通道汽车类 40V 高侧 LED 驱动器
下载选项
评估模块 (EVM) 用 GUI

TPS929120EVM-GUI-SW — TPS929120EVM GUI

支持的产品和硬件

支持的产品和硬件

产品
汽车 LED 驱动器
TPS929121-Q1 — 具有 FlexWire 接口的 12 通道汽车类 40V 高侧 LED 驱动器
硬件开发
评估板
TPS929120EVM — TPS929120-Q1 12 通道汽车 LED 驱动器评估模块
下载
计算工具

SLVRBF8 — TPS92912x-Q1 EEPROM Configuration Tool

支持的产品和硬件

支持的产品和硬件

产品
汽车 LED 驱动器
TPS929120-Q1 — 具有 FlexWire 接口的 12 通道汽车类 40V 高侧 LED 驱动器 TPS929121-Q1 — 具有 FlexWire 接口的 12 通道汽车类 40V 高侧 LED 驱动器
下载
模拟工具

PSPICE-FOR-TI — 适用于 TI 设计和模拟工具的 PSpice®

PSpice® for TI 可提供帮助评估模拟电路功能的设计和仿真环境。此功能齐全的设计和仿真套件使用 Cadence® 的模拟分析引擎。PSpice for TI 可免费使用，包括业内超大的模型库之一，涵盖我们的模拟和电源产品系列以及精选的模拟行为模型。

借助 PSpice for TI 的设计和仿真环境及其内置的模型库，您可对复杂的混合信号设计进行仿真。创建完整的终端设备设计和原型解决方案，然后再进行布局和制造，可缩短产品上市时间并降低开发成本。

在 PSpice for TI 设计和仿真工具中，您可以搜索 TI (...)
发送申请
封装 引脚 下载
HTSSOP (PWP) 24 查看选项
应遵守 TI 评估类商品的标准条款与条件。

订购和质量

包含信息：
  • RoHS
  • REACH
  • 器件标识
  • 引脚镀层/焊球材料
  • MSL 等级/回流焊峰值温度
  • MTBF/时基故障估算
  • 材料成分
  • 鉴定摘要
  • 持续可靠性监测
包含信息：
  • 制造厂地点
  • 封装厂地点

推荐产品可能包含与 TI 此产品相关的参数、评估模块或参考设计。

支持和培训

视频