HDC3020

• Relative humidity (RH) sensor:
  • Operating range: 0% to 100%
  • Accuracy: ±1.5% typical
  • Drift Correction: reduces offset to return device to within accuracy specification
  • Long-term drift: 0.21%RH/yr
  • Condensation protection with integrated heater
• Temperature sensor:
  • Operating range: -40°C to 125°C
  • Accuracy: ±0.1°C typical
• NIST traceability: Relative humidity & temperature
• Low power: average current 0.7 µA
• I²C interface compatibility up to 1-Mhz speeds
  • Four selectable I²C addresses
  • Command/data protection through CRC checksum
• Supply voltage: 1.62 V to 5.50 V
• Available auto measurement mode
• Programmable interrupts
• Programmable measurement calibration
• Factory-installed polyimide tape assembly cover
• Factory-installed IP67 rated environmental cover

The HDC302x is an integrated capacitive based relative humidity (RH) and temperature sensor, which provides high accuracy measurements over a wide supply range (1.62 V – 5.5 V), along with ultra-low power consumption in a compact 2.5-mm × 2.5-mm package. Both the temperature and humidity sensors are 100% tested and trimmed on a production setup that is NIST traceable and verified with equipment that is calibrated to ISO/IEC 17025 standards.

Drift Correction reduces RH sensor offset due to aging, exposure to extreme operating conditions, and contaminants to return device to within accuracy specifications. For battery IoT applications, auto measurement mode and ALERT feature enable low system power by maximizing MCU sleep time. There are four different I²C addresses that support speeds up to 1 MHz. A heating element is available to dissipate condensation and moisture.

The HDC3020 comes in an open cavity package without a protective cover. Two device variants have a cover option to protect the open cavity RH sensor: HDC3021 and HDC3022. HDC3021 has removable protective tape to allow conformal coatings and PCB wash. HDC3022 has a permanent IP67 filter membrane cover to protect against dust and water.